Page 291 - Brewers Catalogue 2024

Dock Hardware

Floating Dock Hardware is designed for use with 1-1/2”
thick lumber (minimum width 6”). All hardware is
mounted with 3/8” carriage bolts. All male and female
dock to dock connections are made with either 3/4”
bolts and lock nuts or 3/4” connecting pins.

TD24279 Lag bolt, washer set 8/bag
TD24287 3/8”x2”
Hex Bolt set, 8/bag
TD24289 3/8”x3”
3/4” x 3-1/2”
TD24292 3/8”x5”

TD25491 TD26380 TD26391 TD26400 TD26401 TD26402
Male outside corner Heavy duty angle for Piling hoop. Heavy Female outside Inside corner. Heavy Outside corner end
has one 1/2” welded all cross supports duty 1/4” galvanized corner has two 1/2” duty should be used Use this corner at
tab. 4”L x 7”H steel, 5” radius for welded tabs with one of the outside ends of fingers
10” piles corner 8-1/4”L x 5”H
10”L x 5”H 10”L x 5”H
3”H x 16” x 3”

TD26404 TD26405 TD26406 TD26407 TD26408 TD26409
Inside corner/pipe hold- Inside corner/pipe hold- Heavy duty angle for Female T connector Male T connector has Washer plate use two
er 2”. Should be used er 3”. Should be used all cross supports has two welded 1/2” one welded 1/2” tab. plates with each
as an internal pipe hold- as an internal pipe hold- 2-1/2”L x 5”H tabs. Bolts to side of Use with female T angle 1-1/2”L x 5”H
er to give strength to er to give strength to dock to attach fingers connector to attach
the frame 8-1/2”L x 5”H the frame 8-1/2”Lx5”H 5”L x 5”H fingers 5”L x 5”H

TD26410 TD26411 TD26413 TD26414 TD26418 TD26428
Chain retainer bolts to Pipe holder/outside Back up plate Bracket and roller can be Outside corner/male Outside corner end
side of dock to hold 3”. Bolts to outside 5” x 5” added to aid up and down Use with a female Use this corner at
dock in place Can use of dock. Uses 2” pipe motion of the dock in areas outside corner to ends of fingers
1/4,3/8, & 1/2” chain with tidal action. 6” roller connect docks end to
to hold dock in place 5/8” shaft, 3/8” bracket 12-1/4”L x 5”H
5”L x 5”H end 10”L x 5”H

TD26431 TD26531 TD86900 TD86901 TD86902 Carriage bolt set includes
Inside rolling ramp Connector pin set Clamp receiver with slotted receiver with Slotter receiver mounts to bolt,flat washer and nut.
Hot dipped Gavanized
bracket 5” x 11”, 1/4” galvanized 3/4” pin cross beam, easily cross beam the side and underside 8/bag
galvanized steel left & frame of wood and certain
and hitch clip pin slides onto the bottom
right ramp brackets rail of truss style docks metal dock and decks TD26535 1/2” x 3”
TD26536 1/2” x 5”
270 Phone: 1-800-263-8328